GRACO 16H294 - Adapter, Angled, Expanding Blade

Angle adapter designed for reduced vortexing and off-center mounting with expanding blade agitators. Enables optimal positioning for foam, polyurea, and general finishing applications in sealed containers.

Features

• Reduces vortexing during mixing
• Enables off-center mounting
• Works with expanding blade agitators
• Customizes agitator configuration

Applications

• Foam applications
• Polyurea applications
• General finishing
• Sealed container mixing with 1-1/2 inch or 2 inch bung access

Compatible Equipment

• 24C728 Low Viscosity 1 HP agitator
• 24C729 High Viscosity 1.75 HP agitator
• Small and large blade assembly configurations
• drums with off-center bung where blades would contact the side of the drum

Related Parts

• 16H295 - Angle Adapter Locking Ring
• 24C860 - Small Blade Assembly Kit
• 24C861 - Large Blade Assembly Kit

Part of accessory system to customize agitator configuration for specific application needs. Works with both low and high viscosity agitator models. Used with locking ring 16H295. Thread the locking ring onto the angled adaptor by hand, then thread the angled adaptor into the bung until it bottoms out, then back it out until the widest portion of the adaptor top is pointing just to the left of the center of the drum. Turn down the locking ring until it contacts the drum and tighten until the widest portion of the adaptor top is in line with the drum. References additional information on page 6 under 'Angled Adaptor' section. Related to part 16H295 (RING, locking) which also references the same Angled Adaptor section.

Reference Manuals

• 344830 (Page 2) Expanding Blade Agitator
• 313643 (Page 6) Expanding Blade Mixer
• 3A4792 (Page 12) Air-Driven Agitators, Instructions-Parts List
• 3A5453 (Page 7) Air-Driven Expanding Blade Mixer, Instructions, Parts