Simpson Strong-Tie HWDC5.25-KT25 Head of Wall Drift Clip 5.25" Kit
Product Details
Made for Versatility, with Proven Strength and Stiffness
The head-of-wall drift-clip connector (HWDC) is used to secure the head of a wall to the bottom of a slab or beam. The unique design allows anchor screws to be installed closer to the bend, providing a stronger and stiffer connection while also allowing horizontal and vertical movement during seismic and high-wind events. HWDC5.25 provides anchorage location options with a third slot providing a solution for clips overhanging beam flanges.
HWDC connectors are an optimal solution for adding strength to window or door jambs at head-of-wall connections. Tested load values are provided for anchorage to steel and concrete.
Key Features
- Accommodates 1" of lateral drift in each direction, and 1" of upward and downward vertical deflection
- Unique design and placement of the anchorage slots allows for closer attachment of anchorage to the clip bend, providing increased load capacity
- The HWDC5.25 clip has three slots located at the anchorage leg allowing for attachment at the outer slots (anchorage pattern — centered) for maximum capacity or anchorage to the adjacent slots (anchorage pattern — off center) for walls that overhang the edge-angle or beam-edge
- Stiffening ribs are placed in between anchorage slots through the bend to provide additional strength and stiffness
- Simpson Strong-Tie® No-Equal® stamps mark the center of the slots to help ensure proper shouldered screw and anchor placement
Product Includes
- (55) XLSH78B1414 shoulder screws are provided with each order
Material
Finish
Installation
- Use the specified type and number of fasteners and anchors.
- In the vertical slots, use the specified number of #14 shoulder screws (included) for attachment to the stud. Install screws to align with No-Equal stamp.
- For attachment to steel, use Simpson Strong-Tie Strong Drive® XL Large-Head Metal Screws (XLQ114B1224). Use two screws centered in horizontal slot. Install screws to align with the No-Equal stamp and then back out one half-turn.
- For attachment to concrete, use a Titen Turboâ„¢ screw anchor. Use two screws centered in each horizontal slot. Install screws to align with the No-Equal stamp and back out half-turn.
Ordering Information
- HWDC5.25-KT25, HWDC3.37-KT25 — (55) XLSH78B1414 #14 shoulder screws are provided with each order
- Replacement #14 shoulder screws for the HWDC are XLSH78B1414-RP83
