Simpson Strong-Tie IDCB45.5-KT25 Drift Clip 3.5" x 5.5" x 4" 12Ga w/Screws 25ct

Drift Connectors

Product Details

The IDCB drift-clip connector is used to secure bypass stud framing to the edge of a slab. The connector will accommodate 1" of lateral drift in each direction and 1" of upward and downward vertical deflection. Tested load values are provided for anchorage to a steel-edge angle using #12 x 1 1/4" Strong-Drive^® XL Large-Head Metal screws.

Key Features

• Horizontal embossments and corner gussets optimize performance in the F₂ load direction
• Precision-manufactured shouldered screws provided with the IDCB connector are designed to prevent overdriving and to ensure that the clip functions properly
• Simpson Strong-Tie No-Equal^® stamps mark the center of the slots to help ensure correct shouldered screw and anchor placement

Material

• 97 mil (12 ga.), 50 ksi

Finish

• Galvanized (G90)

Installation

• Use the specified type and number of fasteners and anchors.
• In the vertical slots, use the specified number of #14 shouldered screws (included) for attachment to the stud. Install screws to align with the "No-Equal" stamp.
• For attachment to a minimum 3/16"- and maximum 1/2"-thick steel-edge angle, use Simpson Strong-Tie^® Strong-Drive XL Large-Head Metal screws (XLQ114B1224). Use one screw centered in each horizontal slot. Install screws to align with the No-Equal stamp and back out 1/2 turn.
• For fastener installation into steel backed by concrete, predrilling of both the steel and the concrete may be required. For predrilling, use a maximum 3/16"-diameter drill bit.

Ordering Information

• IDCB45.5-KT25 contains (25) IDCB45.5 connectors and (83) XLSH78B1414 #14 shouldered screws