Simpson Strong-Tie STB2-756144SS 3/4" x 6-1/4" 304SS Strong-Bolt2 Anchor 10ct

A wedge-type expansion anchor designed for optimal performance in cracked and uncracked concrete as well as uncracked masonry. The Strong-Bolt 2 is available in carbon steel, Type 304 and Type 316 stainless steel.

• Code listed under IBC/IRC for cracked and uncracked concrete per ICC-ES ESR-3037
• Code listed under IBC/IRC for masonry per IAPMO UES ER-240
• Qualified for static and seismic loading conditions (seismic design categories A through F)
• Suitable for horizontal, vertical and overhead applications
• Qualified for minimum concrete thickness of 3 1/4", and lightweight concrete-over-metal deck thickness of 2 1/2" and 3 1/4"
• Standard (ANSI) fractional sizes: fits standard fixtures and installs with common drill bit and tool sizes
• Tested per ACI355.2 and AC193

1. Drill a hole in the base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed. Drill the hole to the specified minimum hole depth, and blow it clean using compressed air. (Overhead installations need not be blown clean.) Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling.
2. Assemble the anchor with nut and washer so the top of the nut is flush with the top of the anchor. Place the anchor in the fixture, and drive it into the hole until the washer and nut are tight against the fixture.
3. Tighten to the required installation torque.

• Do not use an impact wrench to set or tighten the Strong-Bolt 2 anchor
• Oversized holes in the base material will make it difficult to set the anchor and will reduce the anchor's load capacity

Specifications: