Simpson Strong-Tie THD5093437RC - 1/2" x 9-3/4" Rod Coupler for 3/8" Rod

The Titen HD Rod Coupler is designed to be used in conjunction with a single or multi-story rod tiedown system. This anchor provides a fast and simple way to attach threaded rod to a concrete stem wall or thickened slab footing. Unlike adhesive anchors, the installation requires no special tools, cure time or secondary setting process; just drill a hole and drive the anchor.

Features

• Code listed in ESR-2713 for wind and seismic loading.
• The serrated cutting teeth and thread design enable the Titen HD rod coupler to be installed quickly and easily. Less installation time translates to lower installed cost.
• The specialized heat-treating process creates tip hardness to facilitate cutting while the body remains ductile.
• No special setting tools are required. The Titen HD rod coupler installs with regular or hammer drill, ANSI size bits and standard sockets.
• Compatible with threaded rods in 3/8" and 1/2" diameters.
• Use in dry interior environments only.

Material

• Carbon steel

Finish

• Zinc plated

Installation

1. Drill a hole using the specified diameter carbide bit into the base material to a depth of at least 1/2" deeper than the required embedment.
2. Blow the hole clean of dust and debris using compressed air. Overhead application need not be blown clean.
3. Tighten the anchor with appropriate size socket until the head sits flush against base material.